VARIABLE OFFSET HOLDER AND STRAIGHT SHANK TIPS

These offset holders provide a range of offset dimensions rather than one fixed amount, as with other one-piece offset holders. The top has a long shank and can be moved in or out to vary the offset anywhere between four and five inches.

The holders, all of Class 3 alloy, are made in three barrel diameters: 1, 1-1/4, and 1-1/2 inches.

The tips are positional because they have no taper: they have straight shanks, and are held in any selected position by a locking-wedge device in the holder.

Tips are made in one and two-piece designs. The one-piece tips are offered with the nose designs shown. The two-piece tips are made up by combining the shanks shown here with Tuffcap caps (normally used with No. 5 RW size Tuffcap shanks). Either male or female tips can be used, with any nose design offered. All integral tips and shanks shown here are of Class 2 alloy.

STRAIGHT-SHANK TIPS Type of Tip  Nose Length 'A' Description Item No. Pointed 1" SE-4408-1 170-4408 Offset 1" SE-4409-1 170-4409 15 Dome 1" SE-4410-1 170-4410 30 Dome 1" SE-4411-1 170-4411 Pointed 2" SE-4408-2 170-4418 Offset 2" SE-4409-2 170-4419 15 Dome 2" SE-4410-2 170-4420 30 Dome 2" SE-4411-2 170-4421

	SE-4412
	SE-4413
	SE-4414
	SE-4415
STRAIGHT-SHANK TUFFCAP SHANKS Tuffcap Cap Type  Nose Length 'A' Angle Description Item No. Male 3/4" 90 SE-4412 170-4422 Male 3/4" 15 SE-4413 170-4423 Female 1" 90 SE-4414 170-4424 Female 1" 15 SE-4415 170-4425

HOME