 | Spot Weld - Seam Weld - Roll Spot Weld - Butt Weld
|
| Cascade 6 Guns with Clamp Output, Chained or Successive
|
| Cascade 24 Guns successively, one per Weld Schedule
|
| Cascade 6 Welding Transformers, Chained or Successive
|
| Manual Valve Select Program |
| Fully Programmable 300 Weld Schedules |
| Single - Dual - Triple Foot Switch Control |
| 87 Degree Fire Limit Control First Cycle |
| 1/2 Cycle Alternate Polarity Firing |
| Water Cooled Contactor with Over Temperature Shut Down
|
| Pulsating Heat Control |
| One Time Squeeze Delay in Repeat |
| Upslope Heat Control |
| Temper Heat Control |
| Intermittent Drive Motor On/Off Control |
| Forge Delay Start |
| Dual Mode Anti-Tie Down Initiation (momentary or push-and-hold)
|
| Constant current Control or A.V.C. |
| Built-in Weld Current Checker with 1% to 20% Allowable Deviation Error
with Deviation Error Display and Constant Current or AVC Mode |
| Conversion to Model 108A Stepper Heat Control |
| Weld/Forge Pressure Control Regulator |
| Cylinder Pressure Hi-Low Limit |
| Motor Speed Control |
| RS 232 Upload/Download Weld Schedules to PC |
| RS 232 PLC Control Interface |
| Edit Weld Schedule Key Lock |
| 108LD Load Distribution over 3 Phase Line with 16 Valve/12 Transformers
Manual Valve and Transformer Selection |
| 8 Limit Switches Allow Part in Position, Guns Up Detection and Weld
Schedule Selection |
| INPUT POWER: 200 VAC to 480 VAC 60 HZ. |
| AC OUTPUT TO VALVES: 115 VAC 20 VA. EA. |
| Solid State Contactors Available in Ranges from 300 Amps to 3200 Amps |
| Ignitron Firing Module to Fire Ignitrons Size A through E |
| Solid State Relays to Operate Squeeze Valve in Spot - Seam - Rollspot -
Cascade - Butt Weld |
| End of Sequence Output |
| Optional Solid State Relays to Operate Clamp, Retraction, Tip Dress, Upset
Valves |
| Optional Solid State Relay to Turn on Motor or Air Brake in Seam or
Rollspot Mode |
A
World Of Resistance Welding
